Research on the pore spatial distribution and its correlation with mechanical properties of polymer grouted sand
Аннотация
Permeation grouting is an effective technique for mitigating seepage and soil instability in underground engineering, achieved by reinforcing soil layers and sealing water inrush pathways. Polymer-based grouting materials, owing to their rapid solidification and high permeability, have been widely applied; however, the resulting grouted sand exhibits complex and heterogeneous microstructural characteristics. To elucidate the spatial distribution of micropore structures in grouted sand, constant flow (CF) and constant pressure (CP) grouting experiments were conducted under different hydraulic heads ( H ) and mass fractal dimensions ($$D_m$$). The evolution of microstructures was characterized through mercury intrusion porosimetry, scanning electron microscopy, and X-ray diffraction. Furthermore, the pore size distributions at different spatial positions were correlated with the unconfined compressive strength (UCS). The results demonstrated that: (1) CF mode produced a more uniform pore distribution compared with CP mode. Within 20 cm of the injection port, porosity downstream was significantly lower than that upstream, and the location of minimum porosity was shifted downstream. (2) Lower porosity indicated better consolidation. Overall porosity decreased with increasing $$D_m$$, whereas both excessively high and low H values hindered slurry diffusion and consolidation. A moderate H promoted the formation of low porosity grouted sand. (3) During failure, cracks predominantly propagated through large pore regions with weak polymer–sand bonding. X-ray diffraction analysis showed that no new mineral phases were detected, suggesting that the consolidation mechanism was governed primarily by physical filling and interfacial bonding. (4) A negative correlation was observed between porosity and UCS. CF mode showed advantages in both strength enhancement and overall water-blocking performance, although both modes maintained high water-blocking ratios after grouting.