Experimental investigation of the stress-induced anisotropic effects on the unsaturated yield surface of tailings materials
Аннотация
Drying of tailings in sections of tailings-based earth structures, such as tailings dams, often leads to structural defects particularly tensile cracking which can undermine stability. Understanding and mitigating these phenomena require accurate modeling of the yielding behavior of these materials under unsaturated conditions. However, this critical aspect has garnered limited attention in the existing literature. To address this knowledge gap, a comprehensive experimental program was conducted, including micromechanical analyses using scanning electron microscopy (SEM), X-ray diffraction (XRD), and energy-dispersive X-ray spectroscopy (EDS). Additionally, strain-controlled and different stress-path triaxial tests were performed on reconstituted tailings samples collected from the Sungun copper mine, under low relative compaction, isotropic and anisotropic confinement, and various matric suction levels. Microstructural investigations revealed that macropores progressively decreased with increasing consolidation stresses, influencing both the soil–water characteristic curve (SWCC) and the unsaturated yielding response. Yield points obtained from stress-path triaxial tests were evaluated against existing models, which exhibited limited predictive accuracy. After modifying the yield formulation of ABBM1—a stress-based anisotropic model—the corrected version successfully reproduced the experimental yielding points with significantly improved accuracy (RE = 5.3%). Further analyses show that the associated flow rule for these yield surfaces exhibits non-associated behavior. Additionally, the slope of the critical state line was observed to increase with suction. These findings provide important insights for predicting and enhancing the stability of tailings-based earth structures under drying conditions. Graphical abstract