Development of a Thermal Oil Pentane Evaporator Design for an ORC Unit
Аннотация
Abstract— A vapor generator is among the most complex and thermally stressed component of the thermal cycle circuit of a power unit operating according to the organic Rankine cycle (ORC). As a rule, the ORC unit vapor generators intended for recovering the waste heat in industrial processes are “connected” to the source via an intermediate thermal oil loop. With such an arrangement, thermal oil, which has the maximum possible temperature, enters sequentially first the vapor generator’s evaporating and then heating part, in which it transfers heat to the power unit’s low-boiling working fluid (LBWF). The study addresses matters concerned with designing the evaporator, in the tubes of which the LBWF is heated to the saturation temperature at a specified pressure, boils, and is superheated prior to be supplied to a turbine (an expansion engine). Oil coolers of stationary power units operating on steam as working fluid are considered as prototypes for design implementation of the ORC unit evaporator: vertical shell and tube devices, including those with smooth tubes, with “disc–ring” type partitions with nonsealed and sealed process gaps, as well as with low knurled fins on tubes, with “disc–ring” type partitions, and sealed process gaps. The article presents the results of a review of experimental data and applicability analysis of existing models for calculating the heat transfer coefficient and critical heat flux for LBWF boiling in tubes, which can be recommended for including them into the device thermal-hydraulic design calculation. The procedure for calculating the pentane evaporator for a thermal capacity of 1440 kW for a 500 kWe ORC unit has been tested. A “field of solutions” has been obtained for the layout versions of the evaporator heat transfer surface composed of tubes made of carbon steel, stainless steel, brass, and copper, having an outer diameter of 10, 12, 14, 16, and 18 mm and wall thickness from 0.5 to 2.5 mm, as well as finned tubes the finning ratio of which was varied from 2.2 to 2.4. By applying correlation analysis methods, a data array on the optimal layout versions of the heat transfer surface for devices of all designs considered has been set up. Recommendations on selecting the design version of a pentane evaporator as part of an ORC unit have been compiled.