Effective Thermal Conductivity of a Heat Pipe with Forced Working Fluid Pulsations
Abstract
Abstract— The effective thermal conductivity of a pulsating heat pipe (also referred to as a dream pipe) is studied. In heat pipes of this type, longitudinal heat transfer is enhanced owing to forced working fluid pulsations. The operating parameters on which the solution of the problem depends are determined: the thermal Womersley number Wo T l determined based on the tube length l and the relative pulsation amplitude $${{k}_{x}} = {{\tilde {x}}_{m}}{\text{/}}l,$$ where $${{\tilde {x}}_{m}}$$ is the pulsating liquid layer longitudinal displacement amplitude. The heat pipe operation modes are classified. In the case of pulsations with high amplitudes k x $$ \gg $$ 1, the quasi steady state heat transfer mode takes place. For this mode, the analytical solution of the energy equation averaged over the pipe cross section is obtained. The solution of the problem depends on the Peclet number Pe lm , determined proceeding from the amplitude of longitudinal velocity harmonic pulsations and pipe length. It has been found that at high Peclet numbers, the effective thermal conductivity to the immobile liquid layer thermal conductivity ratio $$\Lambda $$ increases in proportion to Pe lm . In the general case, the equation of energy was solved using the finite difference method with applying a newly developed unconditionally stable difference scheme. For practical use of calculation results, the indicator $$\Lambda $$ is represented as a dependence on the thermal Womersley number Wo t and dimensionless longitudinal displacement $$\Delta X = {{\tilde {x}}_{m}}{\text{/}}h$$ (where h is the channel hydraulic radius). The pulsating heat pipe efficiency η has been calculated, which is defined as the ratio of thermal power transmitted in the longitudinal direction to the power required to excite forced working fluid pulsations. It is shown that under quasi steady state hydrodynamic conditions the coefficient η reaches high values. The pulsating heat pipe optimal parameters have been estimated.