Mathematical Simulation of Compressor Flow Path Inlet Compartments Icing under Adverse Weather Conditions

Instruments and Experimental Techniques · Springer Nature · 2026-09-01 · DOI: 10.1134/S0040601526700333

Аннотация

Abstract— Ice accretion on the components of on-land power equipment and aircraft equipment under harsh weather conditions adversely affects their operation. Icing may emerge both near the ground surface and at significant altitudes. The article proposes an advanced 3D ice accretion model, which covers a wide range of outdoor conditions (supercooled droplets, dry ice crystals, and mixed phase), as well as various icing surface states (dry or moistened, heated or nonheated). Special attention is paid to simulating the processes in the compressor flow path, in particular, to ice accretion on dry heated surfaces when a flow of dry ice crystals deposits on them. The model describes conjugate unsteady heat transfer from an object’s heated surface to the accreting ice buildup, which has a complex multilayer inner structure. The ice layer may contain accumulated liquid water. This water can flow over the ice surface in the form of hillocks, rivulets, and films, and in the case of submelting, cavities filled with liquid water may occur on the heated surface. The predicted ice locations and mass and dimension characteristics are compared with experimental data obtained on the compressor flow path model. It has been confirmed that the interconnected and interrelated physical effects accompanying ice accretion, such as heat and mass transfer, the degree to which ice crystals are submelted in the carrier flow and captured by the ice buildup surface, as well as ice erosion, are described in a correct way. In carrying out predictions, a Pi-shaped curve representing the dependence of ice buildup rate on the crystals submelting degree has been obtained, which is in good agreement with the experimental data.

Читать у издателя →

Похожие статьи