An implicit elastoplastic finite-deformation framework for spudcan bearing capacity analysis with mitigation of spurious stress concentrations

Discover Applied Sciences · Springer Nature · 2026-11-03 · DOI: 10.1007/s11440-026-03249-2

Аннотация

Accurate prediction of spudcan bearing capacity and the associated soil stress distribution is critical for the safe installation of jack-up offshore platforms. The bearing capacity is commonly evaluated using small-strain finite element methods (FEM); however, due to the conical geometry of spudcans, severe element distortion may occur. This can lead to artificial stress concentrations near the spudcan tip, resulting in unrealistic stress fields and biased capacity estimates. This paper proposes an implicit elastoplastic finite-deformation framework incorporating a skew-boundary interface formulation to overcome mesh distortion and eliminate spurious stress concentrations. In the proposed approach, both the mesh and geometry are continuously updated during deformation, enabling a consistent representation of large soil deformation without the use of artificial viscosity or rate-dependent regularization. Structural components are modeled as linear elastic, while soil behavior is described using the Mohr–Coulomb yield criterion. Model performance is first validated through comparison of bearing capacity factors for wedge-shaped footings with apex angles ranging from 30° to 150° against published solutions. The method is subsequently applied to spudcans with fully open cavities embedded in soil. The results demonstrate that the proposed formulation effectively mitigates spurious stress concentration and yields physically consistent stress distributions and bearing capacity predictions over a wide range of embedment depths.

Читать у издателя →

Похожие статьи