The Influence of Quantitative and Qualitative Composition of Deposits on the Damageability of High Pressure Boiler Waterwall Tubes
Аннотация
Abstract The operational effectiveness and safety of high-pressure boilers depend on the condition of their heat transfer surfaces. The formation of multilayer deposits on the inner surfaces of waterwall tubes gives rise to problems, especially when there is an impact of steam–water mixture. In carrying out this research, the experiments on studying the composition and structure of deposits were combined with numerical simulation with the aim to quantify the effect of deposits on the temperature distribution in multilayer metal–deposit systems. It has experimentally been found in the course of studies that the deposits form two- and three-layer structures, the thermal conductivity of which varies from 0.37 W/(m K) for silicate–phosphate layers to 1.5 W/(m K) for oxide ones. A mathematical model that takes into account a two-phase steam–water flow, multilayer structure of deposits, and temperature dependent properties of materials has been developed and verified. Predictions show that with the working medium density equal to 136 kg/m 3 and fouling equal to 600 g/m 2 , the tube temperature may reach 427.5°C, which is by 43°C higher than the critical value for grade 20 steel. The flow velocity ranges and the deposit compositions at which local heating becomes the tube damageability governing factor have been determined. It has been found that there is a linear dependence of the temperature increment on the deposit layer thickness in the range 48‒219 μm. The numerical simulation results agree with the experimental data with an rms error of less than 3%. The obtained results open the possibility to develop recommendations on monitoring the water chemistry, forecasting the limit operation conditions, and optimizing the frequency of chemical washing operations of heating surfaces to prevent waterwall tube damages.