Wear of St3 Steel and Oxygen Distribution on Its Contact Surface during Unlubricated Sliding against 45 Steel under Electric Current
Аннотация
Abstract The aim of this study was to establish the relationship between the tribotechnical characteristics of St3 steel and the structural state of its contact layers during unlubricated sliding against hardened 45 steel under an electric current with a density exceeding 100 A/cm 2 . Unlubricated sliding of a model St3kp steel specimen against hardened 45 steel was carried out under an alternating current with a density of up to 340 A/cm 2 using a pin-on-ring contact configuration. Electron microscopy revealed the formation of a tribolayer less than 20 μm thick in the contact region of the St3 steel specimen. The worn surface was also found to be divided into two sectors. The sector oriented opposite to the direction of motion of the counterbody’s contact surface exhibited signs of adhesion, ploughing, and abrasive destruction. The other sector, oriented in the direction of the receding contact surface of the counterbody, showed features of destruction in the presence of a viscous liquid. No signs of adhesion were observed in this sector. The boundary between the sectors was not sharp, and a gradual transition from one sector to the other was observed. X-ray phase analysis of the tribolayer established the formation of FeO. X-ray energy-dispersive microanalysis of the worn specimen surface after sliding was used to determine the oxygen concentration in both sectors. The oxygen concentration in the sector containing signs of melting was markedly higher than that in the other sector. It was assumed that the melt consisted of iron and oxygen atoms. This melt increased the electrical conductivity of the contact and reduced the friction coefficient as the contact current density increased. The results obtained are useful for understanding the processes occurring in an unlubricated metal–metal friction zone under electric current. Information on the electrical conductivity and wear of St3 steel may serve as a reference for designing current-collecting friction assemblies for high-power low-voltage electric motors and generators.