FEM Simulation of Highway Tunnel Vibrations Induced by Moving High-Speed Train Loads
Аннотация
The structural integrity of highway tunnels situated beneath railroad tracks is a critical engineering challenge. High-speed trains exert significant dynamic loads, leading to vibrations, stress concentrations, and dynamic amplification that can compromise safety. Despite its importance, a notable research gap remains in parametric investigations of the modal and dynamic characteristics of these specialised tunnel configurations. This study aims to assess the structural response of an existing railway-track/ground structure and the highway tunnel beneath it to imposed moving axle loads representative of high-speed trains. The goal is to measure the tunnel system's deformation, stress, velocity, and acceleration responses under various railway loading conditions and train speeds. A fully coupled vehicle/track/ground/tunnel interaction model, including explicit vehicle suspension and wheel/rail contact interaction, has not been developed. The three-dimensional transient finite element model of the railway track, surrounding ground, and highway tunnel was built in ANSYS. The prescribed axle forces are applied to the train, which travels along the track at a constant speed and maintains the same axle magnitudes and longitudinal spacing as the load configurations selected from Indian Railways. This results in a moving-load model coupled to the track–ground–tunnel structural system, rather than a complete vehicle–track–ground–tunnel interaction model. The results indicate that damping, surrounding rock grade, train speed, and loading condition are important parameters to consider for the dynamic response of the track–ground–tunnel system. All reported equivalent (von Mises) maximum stresses are considered elastic response demand indicators for the assembly and are not assigned to the tunnel lining itself without component-level verification. They are not considered stresses acceptable in concrete, since a linear-elastic (LE) constitutive law is used for the tunnel lining and no cracking, crushing, fracture energy, or damage evolution are considered. The present study thus focuses on deformations, velocities, accelerations, and elastic stress demands for the given moving axle loads, with structural safety against concrete cracking or crushing considered only through a dedicated non-linear concrete analysis based on principal tensile/compressive stresses and corresponding strength and damage parameters. The existing research is limited to analysing tunnel structures. Tunnel and railway engineers can use this study to further assess fatigue in highway tunnels under various dynamic loads from railway traffic. From a geotechnical engineering standpoint, the results highlight the importance of layered-ground stiffness and strength, stress confinement, damping, groundwater conditions, and ground–tunnel load transfer in controlling the dynamic response.