Micropiles for Solar Structures in Lateritic Residual Soils of Northeastern Argentina: LRFD Calibration Using Pull-Out Tests

Journal of Ocean Engineering and Marine Energy · Springer Nature · 2026-11-10 · DOI: 10.1007/s40098-026-01658-4

Аннотация

Micropiles supporting lightweight solar panel structures may be governed by wind-induced pull-out. Few LRFD resistance factors calibrated with full-scale pull-out tests are available for lateritic residual soils, because most published databases concern sedimentary soils or conventional foundations. This study presents a first regional reliability-based calibration using 24 tests conducted in Misiones, Argentina. Four pre-test predictive approaches were evaluated: the combined alpha-beta formulation, FHWA, a simplified implementation of Misra–Chen, and Bustamante and Doix. Bias was defined as the ratio of measured to calculated capacity. Calibration was performed using Monte Carlo simulation and the inverse first-order reliability method (FORM), with dead load treated as a stabilizing action against the wind-induced pull-out load transmitted to the foundation. Measured loads ranged from 15.14 to 39.46 kN. All four pre-test methods were conservative on average, with mean resistance bias factors λ R ranging from 1.12 to 1.40. A two-way ANOVA showed significant effects of embedded length and diameter, with a larger effect associated with embedded length and no significant diameter–length interaction. For a target reliability index of 3.0 and 1 ≤ r ≤ 3, single conservative resistance factors based on the lower Monte Carlo envelope are 0.81, 0.63, 0.69, and 0.66 for alpha-beta, FHWA, Simplified Misra–Chen, and Bustamante and Doix, respectively. These values are conditional on the nominal models, on the tested geometry (d = 0.15–0.25 m; L = 1.50–1.90 m), and on the field moisture conditions represented by the tests (natural water content of 20–30%, indicative degree of saturation of about 0.67–0.84).

Читать у издателя →

Похожие статьи