Simulation of the Formation of a Back-End Defect at the Final Stage of Extrusion Taking the Laws of Friction into Account
Аннотация
Abstract The purpose of the work is to simulate the process of forming a back-end defect at the final stage of direct extrusion of a 6061 aluminum alloy bar, taking into account the influence of the law of friction on the surface of the dummy block. As part of the work, four formulations of the extrusion process problem were created with different boundary conditions of friction on the contact surface of the dummy block-billet: the first is Siebel’s law during the entire extrusion process with a friction index of 1, the second is Siebel’s law with a friction index of 1 before the formation of the press plate, then Coulomb’s law of friction with a coefficient of friction of 0.3, the third is Siebel’s law throughout the entire extrusion process with a friction index of 0.1, the fourth—Siebel’s law with a friction index of 0.1 before the formation of the press plate, followed by Coulomb’s law of friction with a coefficient of friction of 0.3. It has been found that an increased friction index leads to a smaller depth and radius of the back-end defect, a higher level of axial stress and the greatest extrusion force. The combination of a reduced value of the friction index according to Siebel’s law with its replacement by the coefficient of friction according to Coulomb’s law after the formation of the back-end defect begins contributes to a maximum increase in the depth and radius of the back-end defect, creating a minimum level of axial stress and extrusion force. As part of the work, the reason for the smaller size of the back-end defect in the case of an increased friction index was determined—the reduced radial velocity of the metal flow on the working surface of the dummy block at the final stage of extrusion. With reduced friction, the radial velocity increases, which leads to the formation of a large back-end defect. Thus, the influence of the law of friction on the contact surface of the dummy block-billet on the formation of the back-end defect has been established.