Specific Energy Modulation and Performance Response of 18Ni300 Fabricated by Laser Metal Deposition

Engineering Research · Springer Nature · 2026-11-13 · DOI: 10.1007/s13369-026-11807-9

Аннотация

Specific energy (Es) is an important parameter for characterizing heat input in laser metal deposition (LMD); however, the relationships among heat input, deposition behavior, microstructure and defects, and mechanical response of LMD-fabricated 18Ni300 maraging steel remain insufficiently understood. In this study, different Es levels were obtained by varying laser power and scanning speed, followed by single-track, multi-track, and multilayer deposition experiments with adjustments of the overlap ratio (OR) and layer increment (ΔZ). The deposition morphology, microstructure, mechanical properties, and fracture behavior were systematically investigated. The results showed that Es significantly affected single-track geometry, penetration depth, and dilution behavior, while appropriate combinations of OR and ΔZ enabled stable multi-track and multilayer deposition. Among the three representative processing conditions, the low-Es condition (61.11 J/mm 2 ) produced a relatively coarse and less uniform microstructure. At the intermediate Es of 72.22 J/mm 2 , a relatively fine and uniform microstructure was obtained, with an average grain size of 3.50 ± 0.21 μm. The yield strength, ultimate tensile strength, and elongation reached 1057.98 ± 22.32 MPa, 1068.27 ± 16.70 MPa, and 12.33 ± 0.24%, respectively, indicating a favorable strength–ductility balance, with fracture surfaces dominated by fine, uniformly distributed dimples. At the high Es of 85.71 J/mm 2 , more pronounced porosity was observed; although the highest hardness (38.3 ± 1.8 HRC) was achieved, the tensile strength decreased. Within the investigated processing window, moderate heat input combined with appropriate OR and Δ Z promoted stable deposition, while microstructural uniformity and metallurgical defects were important factors governing the overall mechanical response.

Читать у издателя →

Похожие статьи