Study of Dynamic Adaptation of a Copper Alloy Structure to Friction Conditions in a Nanomodified Lubricant Environment

Science China Physics, Mechanics & Astronomy · Springer Nature · 2026-04-01 · DOI: 10.3103/S1068366626700339

Аннотация

Abstract Friction pairs consisting of LAS53 brass and 45 steel were studied in a lubricant composition based on I-20A industrial oil with additives containing a suspension of nanosized serpentine particles and soft metal fatty acid salts. Tests were conducted using a unidirectional sliding pattern with a disk-on-three-pin configuration, reciprocating sliding with a plane-on-plane configuration, and a dedicated worm gear test rig. The dependence of the friction coefficient on the Sommerfeld parameter revealed a “second minimum” at the boundary friction regime, shifted toward higher contact pressures. The increased load-bearing capacity of the friction pair is due to the adaptation of the copper alloy surface layer structure to the active lubricating medium. A modified layer with a heterogeneous structure is formed on the friction surface. It consists of two components: a metallic zone with a reduced dislocation density and enriched with copper, and a viscoplastic thixotropic film formed by nanoparticles, fatty acid salts, and partially polymerized degradation products of the base lubricant. Based on an analysis of the composition and structural state of the surface layer modified by friction, a mechanism for implementing a high degree of deformation of the contact zone material with a low level of destruction under pressures exceeding those permissible for hydrodynamic conditions is proposed. An increase in the load-bearing capacity of sliding matting surfaces during friction in the nanomodified lubricant is demonstrated. This is due to the adaptive behavior of the brass surface layer under contact deformation conditions, the formation of a structural-phase state different from that of the alloy bulk, ensuring increased wear resistance of the structural material and compensation for wear of the friction surface. The use of a nanomodified additive to a base lubricating oil improves the technical condition parameters of sliding joints, including the permissible load.

Читать у издателя →

Похожие статьи