A three-dimensional bond contact law incorporating a failure envelope for use in Discrete Element Method (DEM) to model the mechanical response of bonded granular materials has been developed. The bond between two spherical particles has a curved profile. The macroscopic response of the particle-bond system has been analysed using finite element simulations, wherein the bond material follows a continuum plasticity damage model while the interface failure is modelled by a cohesive surface model. A bond failure envelope is obtained in the normal force, transverse force and torsional moment space. The failure envelope has been formulated in terms of a geometric bond parameter that captures various bond morphologies such as pore-filling, cementation, and load-bearing. The open source DEM solver LIGGGHTS ® has been modified to incorporate bonded interactions with this failure envelope and triaxial simulations, showing its successful implementation.
A Geometry-Dependent Bond Failure Envelope for Use in Discrete Element Method to Model Bonded Granular Materials. // Journal of Ocean Engineering and Marine Energy. – 2026. – DOI: 10.1007/s40098-026-01646-8. – URL: https://link.springer.com/article/10.1007/s40098-026-01646-8
(2026). A Geometry-Dependent Bond Failure Envelope for Use in Discrete Element Method to Model Bonded Granular Materials. Journal of Ocean Engineering and Marine Energy. https://doi.org/10.1007/s40098-026-01646-8
“A Geometry-Dependent Bond Failure Envelope for Use in Discrete Element Method to Model Bonded Granular Materials.” Journal of Ocean Engineering and Marine Energy, 2026. doi:10.1007/s40098-026-01646-8.
@article{article35584,
title = {A Geometry-Dependent Bond Failure Envelope for Use in Discrete Element Method to Model Bonded Granular Materials},
journal = {Journal of Ocean Engineering and Marine Energy},
year = {2026},
doi = {10.1007/s40098-026-01646-8},
url = {https://link.springer.com/article/10.1007/s40098-026-01646-8}
}
The deformation compatibility method enables accurate composite foundation settlement calculation but neglects the regulatory effect of the cushion on pile–soil stress during stress sharing and bearing capacity assessment. To address...
Expansive deposits with low strength and high swelling potential may cause serious damages to overlying embankments, pavements, and foundation of infrastructures. Traditionally binders such as cement, lime, and bitumen have commonly...
Excavation of deep-buried hard rock tunnels is prone to inducing rockbursts. Under plateau high-energy geological conditions, the underlying mechanisms of rockburst initiation and methods for determining optimal support timing remain...
Differential settlement resulting from the spatial variability of soil properties can significantly affect the structural performance of reinforced concrete (RC) frames with unreinforced masonry (URM) infill walls, owing to the low...
Micropiles supporting lightweight solar panel structures may be governed by wind-induced pull-out. Few LRFD resistance factors calibrated with full-scale pull-out tests are available for lateritic residual soils, because most published...