Abstract Cast Ti–Cr boride composites with a Ni–Al–Mn binder were prepared via high-temperature synthesis to develop high-performance surfacing electrodes. It was revealed that the burning velocity and phase composition/microstructure of synthesized products are highly dependent on the initial reactor pressure and charge composition (CrO 3 /TiO 2 /Al/B 2 O 3 ). A specific composite containing 15 wt % metallic binder—derived from a supplemental NiO–MnO 2 –Al mixture—was selected for electric arc surfacing applications. The resulting protective coatings achieved a hardness of 8000–9500 MPa, demonstrating wear characteristics superior to currently available commercial surfacing materials.
Amorphous chalcogenide materials are of increasing interest for phase-change memory and threshold-switching device applications. However, the fast-switching behavior in the nanoscale regime is difficult to confirm and characterize in...
This study investigated the gilding microstructures and manufacturing techniques of a fifth-century Silla horse-harness fitting excavated from the grave-goods compartment of Hwangnam-dong Tomb No. 120-2 in Gyeongju, Korea. The specimen...
Three-dimensional (3D) integrated one-selector one-resistor (1S1R) cross-point arrays are emerging as a leading next-generation memory technology. Achieving both nonvolatile memory switching and volatile threshold switching within a...
Anatase titanium dioxide (TiO 2 ) is widely recognized for its superior photocatalytic capabilities due to its indirect band gap, low cost, and high chemical stability compared to other oxide semiconductors. Despite its advantages, TiO...
Abstract Nano-sized α-Fe 2 O 3 powders were synthesized via a starch-assisted gel-combustion method. The effects of fuel type, equivalence ratio (Φ), and ammonium nitrate addition on phase formation and crystallite size were...