Hydroabrasive Wear of Polyurethane Elastomers as a Function of Hardness
Аннотация
Abstract This paper presents the results of a study examining the relationship between hydroabrasive wear of a series of polyurethane elastomers and their physical and mechanical properties. A series of polyetherurethane urea elastomers based on oligoether of the oligooxytetramethylene diol (polyfurite) type was synthesized. The composition of samples was identical except for the variable plasticizer content, which was dioctyl phthalate. Experimental hydroabrasive wear studies were conducted on a laboratory setup using an aqueous suspension of abrasive powder with a characteristic particle size of 0.5–1.0 mm as the hydroabrasive medium. The physical and mechanical properties of the elastomers were determined for both dry samples and samples swollen to equilibrium in water. The results showed that the dependence of wear intensity on Shore A hardness for the studied materials is an extreme function, with a minimum observed for a sample with a hardness of 58 units. Increased wear intensity was noted for both the hardest and softest samples. Analysis of the surface layer failure pattern of these materials and data on their strain and strength properties led to the conclusion that the wear behavior of softer samples differs due to both plastic deformation of the samples and the additional formation of fracture foci, which may be due to the reduced cohesive properties of these materials.