The Impact of Deep Excavation on Adjacent Existing Pile Foundations and Optimization of Support Parameters
Аннотация
Deep excavation inevitably impacts adjacent structures. Studying the variation patterns under different parameters during this process allows for targeted measures to reduce the disturbance. With this objective in mind, and based on an underground station of the Beijing Subway, a MIDAS-GTS finite element model was first established according to an engineering case to analyze the deformation characteristics of the deep excavation process under the dual support system of “retaining piles + steel struts.” Subsequently, the influence of different parameters on adjacent pile foundations was analyzed using the controlled variable method. The results show that after excavation, the ground surface settlement exhibits a trough-shaped distribution, with a maximum value of 28.22 mm, exceeding the 15 mm limit specified in the code. The existing pile foundation exhibits a maximum settlement of 2.42 mm and a maximum horizontal displacement of 3.42 mm. The parametric analysis showed that the retaining pile diameter had the most significant influence on deformation control. When the retaining pile diameter was increased from 400 mm to 1200 mm, the maximum ground surface settlement, pile foundation settlement, and horizontal displacement decreased by 78.6%, 81.0%, and 85.3%, respectively. Increasing the concrete grade of the retaining piles from C25 to C45 reduced the pile foundation settlement and horizontal displacement by 19.3% and 13.8%, respectively, indicating a relatively minor influence. Increasing only the embedment ratio on the side adjacent to the existing pile foundations from 0.6 to 0.8 effectively controlled the excavation-induced deformation. When the steel strut diameter was increased from 400 mm to 800 mm, the maximum ground surface settlement, pile foundation settlement, and horizontal displacement decreased by 26.8%, 8.6%, and 8.9%, respectively, indicating that the steel strut diameter had a moderate effect on ground surface settlement but only a limited effect on the existing pile foundations. The final optimized scheme consists of retaining piles with a diameter of 1000 mm and C40 concrete, Φ609 × 16 steel struts, and embedment ratios of 0.8 and 0.6 on the near-pile and far-pile sides, respectively. Under this configuration, the maximum ground surface settlement, pile foundation settlement, and horizontal displacement are 13.77 mm, 1.75 mm, and 2.14 mm, respectively, all satisfying the relevant deformation-control requirements.