Method for Calculating Oil Film Thickness between the Teeth of Enclosed Cylindrical Gear Transmissions
Аннотация
Abstract — The work has been aimed at revealing the patterns of changes in the oil film thickness within cylindrical gear transmissions depending on the oil dynamic viscosity, on the total rolling velocity, on the sliding velocity of teeth, as well as on the contact pressure in gear transmissionss under friction. We have studied enclosed-type cylindrical gear transmissions operating in transmission oil under contact stresses not exceeding 2500 MPa and at a bulk oil temperature that does not exeed 150°C were studied. A method has been proposed for the calculation of oil film thickness taking into account the sliding velocity between the contacting surfaces of gears, as well as for the sequence in the calculation of total oil film thickness, taking into account a contact deformation level, the value of which depends on changes in the hydrodynamic properties of oil in the course of friction. Results of studies concerning the factors affecting the oil film thickness between the rubbing surfaces of the teeth at a total rolling velocity of 6.12 m/s have been obtained. The sliding velocity ranges from 1.0 to 3.0 m/s, the contact pressure ranging between 186.9 and 457.9 MPa, the dynamic viscosity of transmission oil being of 17.44–24.24 MPa/s. The calculated values of oil film thickness vary in a wide range from 0.97 × 10 –6 m to 2.06 × 10 –6 m. The patterns of changes in the oil film thickness depending on dynamic oil viscosity at a constant value of the total rolling velocity and contact pressure, as well as depending on the rolling velocity in the presence of slippage between the gears are obtained.