Sustainable Surface Engineering of SS316L Using Room-Temperature Deposited Q-Diamond Coatings for Enhanced Durability
Аннотация
Stainless steel 316L (SS316L) is a low-carbon grade of austenitic stainless steel widely used in biomedical and industrial applications. However, it exhibits limited tribological durability under high contact stresses. In this study, SS316L was subjected to in situ Ar + plasma etching and subsequently coated an approximately ~ 2-μm-thick quench-produced diamond (Q-Diamond) film by coaxial arc plasma deposition method at room temperature. Surface and cross-sectional scanning electron microscopy, together with EDS elemental mapping, revealed a dense and homogeneous nanograined Q-Diamond coating with continuous carbon coverage across the SS316L substrate. The tribological performance of bare and Q-Diamond-coated SS316L was evaluated under harsh dry sliding conditions at applied loads of 10 and 20 N. Bare SS316L exhibited a relatively high coefficient of friction ranging from 0.58 to 0.62 and severe wear damage, whereas the Q-Diamond-coated SS316L maintained a stable and low coefficient of friction of approximately 0.09 with almost no detectable wear. This tribological enhancement is attributed to the dense, hard, and strongly adhered Q-Diamond layer, which prevents direct contact between the counterbody and SS316L substrate, suppresses substrate plastic deformation, and provides a stable low-shear sliding interface. Furthermore, the Al 2 O 3 counterbody exhibited wear rate of 1.31 × 10 −6 mm 3 /N·m against the Q-Diamond, which was substantially lower than the 1.78 × 10 −5 mm 3 /N·m against bare SS316L. These findings demonstrate the potential of Q-Diamond coatings for improving the tribological durability of SS316L under severe sliding conditions.