Designing hierarchical porous carbons from ZIF-8 and biomass/anthracite for CO₂ capture and separation: DFT-guided insights into adsorption mechanisms and performance enhancement

Ionics · Springer Nature · 2026-10-30 · DOI: 10.1007/s10450-026-00719-7

Аннотация

In this study, hierarchical porous carbons were prepared through the high-temperature carbonization of ZIF-8 integrated with activated carbons derived from cotton agricultural waste and anthracite. The effect of the carbonaceous precursor on the textural properties, surface characteristics, and CO₂ adsorption performance of the resulting materials was investigated. Following carbonization, a hot HCl washing step was used to remove residual Zn-containing species and improve pore accessibility. Among the synthesized materials, the anthracite-based composite (C8-AK) exhibited the highest BET surface area of 2307.3 m² g⁻¹ and an average pore diameter of 1.79 nm. It also showed the highest CO₂ uptake, reaching 7.21 mmol g⁻¹ at 1 bar and 8.70 mmol g⁻¹ at 10 bar. The cotton-based composite (C8-SK) exhibited CO₂ uptakes of 6.50 and 7.35 mmol g⁻¹ at 1 and 10 bar, respectively. Both composite materials maintained more than 98% of their initial adsorption capacity after ten adsorption–desorption cycles under the investigated conditions. The adsorption equilibrium data were evaluated using different adsorption models, with the Dual-Site Langmuir–Freundlich model providing the highest fitting accuracy. DFT calculations provided molecular-level insights into the interactions of CO₂ and N₂ with representative adsorption sites, indicating more favorable interactions for CO₂. IAST calculations further indicated higher predicted selectivities for C8-AK in CO₂/N₂ and CO₂/CH₄ mixtures compared with the corresponding unmodified material. However, these selectivity values represent theoretical predictions based on single-component adsorption data and require experimental mixed-gas validation. Overall, the results demonstrate that the selection of carbonaceous precursor can significantly influence the structural and adsorption properties of ZIF-8-derived porous carbons and provide a useful approach for tuning materials for CO₂ capture applications.

Читать у издателя →

Похожие статьи