Experimental investigation on fracturing fluid retention in various types of micro-fractures resulted from water uptake and its impact on permeability evolution in tight reservoirs
Аннотация
Tight reservoirs are typically exploited using a combination technology of long horizontal wells and large-scale hydraulic fracturing. After fracturing fluid enters the formation, it induces various types of micro-fractures. However, the mechanisms and patterns governing fluid retention within these micro-fractures remain poorly understood. To investigate the influence of water-induced micro-fractures on fracturing fluid retention and their differential impact on permeability, spontaneous imbibition tests, Nuclear magnetic resonance (NMR) monitored flowback simulations, and permeability evolution experiments were conducted. The study examined the quantitative relationship between micro-fracture generation and fluid retention, as well as the effect of induced fractures on permeability recovery. The results are as follows: Water uptake in tight reservoirs gradually increases with time yet exhibits significant variations in imbibition characteristics. The imbibition rate, diffusion rate, and imbibition capacity provide quantitative metrics for characterizing these rock-specific absorption behaviors. The Baikouquan formation conglomerate (MH) sample shows the highest imbibition rate, while the Yanchang formation shale (YC) sample exhibits the lowest. The shallow Longmaxi formation shale (LM) sample and deep Longmaxi formation shale (FL) sample demonstrate similar imbibition rates. The diffusion rate of the MH sample is significantly higher than others, with the FL sample outperforming YC and LM. The imbibition capacities of LM, FL, and MH samples are all approximately 0.4. Water-induced micro-fractures in rocks can be classified into four types: bedding-plane micro-fractures, graptolite-rich micro-fractures, rough-surface micro-fractures, and gravel-edge micro-fractures. Significant differences exist in their surface characteristics, retention mechanisms, and retention capacity. The retention rates are approximately 65.8% for bedding-plane micro-fractures, 63.0% for graptolite-rich micro-fractures, 52.1% for rough-surface micro-fractures, and 33.8% for gravel-edge micro-fractures. Well-connected fractures with relatively smooth surfaces, combined with the presence of graptolites, contribute to efficient permeability recovery in the FL and LM samples. The YC sample shows moderate recovery, while the MH sample exhibits poor pore connectivity resulting in slow permeability restoration. Computed Tomography (CT) scans of the fracture distribution within water-absorbing rocks directly demonstrate the influence of fracture networks on permeability recovery. This study provides a theoretical basis for understanding the impact of micro-fractures in tight reservoirs on fracturing fluid retention and hydrocarbon production.