Vanadium(V) sorption onto ion exchange resin with multiple hydroxyl groups
Аннотация
The adsorption behavior of vanadium onto the ion-exchange resin Purolite D3411 was investigated over a wide pH range (2.0–7.5) and in the presence of competitive anions (Cl$$^-$$ and SO$$_4^{2-}$$, 0–1000 mg L$$^{-1}$$). Due to the hydrated nature of the polymeric resin beads, adsorption capacity is expressed on a volumetric basis (mg L$$^{-1}$$), representing an apparent sorption capacity under experimental conditions. Batch experiments revealed a strong dependence of adsorption equilibrium on pH, with a maximum removal efficiency of 78% observed at pH=5.0. Equilibrium data were well described by the Langmuir isotherm model, with a maximum calculated sorption capacity of 90 909 mg L$$^{-1}$$. Adsorption kinetics were evaluated using pseudo-first-order (PFO), pseudo-second-order (PSO), and intra-particle diffusion (IPD) models. At pH=4.5, both PSO and IPD models adequately described the data, indicating contributions of surface adsorption and intra-particle diffusion. At pH=6.0, the PSO model provided the best fit, suggesting that surface reaction kinetics is the rate-limiting step under these conditions. Dynamic column experiments further confirmed the significant effect of solution pH on adsorption performance. Breakthrough curves showed consistently higher adsorption capacities at pH=4.5 compared to pH=6.0 regardless of feed composition. The best performance was obtained at low concentrations of competitive ions (50 and 100 mg L$$^{-1}$$ Cl$$^-$$ and SO$$_4^{2-}$$). Under these conditions, the breakthrough capacity at pH=4.5 reached approximately 50 000 mg L$$^{-1}$$. These results demonstrate that Purolite D3411 exhibits favorable adsorption properties for vanadium removal under mildly acidic conditions, with adsorption governed by pH-dependent equilibrium, kinetic limitations, and competitive ion effects typical for ion-exchange systems in aqueous environments.