Polymer Composites Керамика и композиты

Stacking‐Sequence Effects on Polymer‐Laminate Damage Localization in Al 2 O 3 / UHMWPE and TiB 2 /Kevlar/Al Hybrid Systems Under High‐Velocity Impact

Min Qin, Xiaoying Guan, Jianong Yu, Kai Wang, Bingzheng Lei, Xiaojian Yi, Biao Wang, Yongjun Deng, Guiqin Gu, Tingting Li
Wiley · 2026-11-20 · DOI 10.1002/pc.71831

Аннотация

ABSTRACT Polymer‐fiber laminates dissipate impact energy through tension, interlaminar separation, and deformation, with their response influenced by their position within hybrid targets. One light‐gas‐gun test at approximately 800 m/s was conducted for each of the Al 2 O 3 /UHMWPE and Kevlar/TiB 2 /Al targets. Three‐dimensional LS‐DYNA simulations and rear‐array acceleration measurements were used to investigate the impact response. The simulated Kevlar opening diameter differed from the measured value by 0.9%, while the UHMWPE rear‐face deflection was underpredicted by 19.5%. In ceramic‐front arrangements, ceramic fracture and lateral load spreading preceded pronounced polymer deformation. Reversing the ceramic–polymer order in simulations exposed the polymer to concentrated loading earlier, producing a narrower and more continuous axial tensile–shear damage path. Across the simulated velocity range, the central polymer damage‐zone width increased from 8.3 to 11.4 mm for Al 2 O 3 /UHMWPE and from 10.5 to 12.3 mm for Kevlar/TiB 2 /Al. Simulations bracketed full‐target perforation between 1200 and 1400 m/s in both architectures. In the front‐Kevlar simulations, the central damage path became more continuous between 800 and 1000 m/s while the full target remained unperforated. These velocity‐dependent findings are numerical predictions, with experimental support limited to the tested configurations at approximately 800 m/s.

Читать у издателя →