Photonic Network Communications Software
Performance analysis of power-efficient multidiagonal OCDMA passive optical network
Abstract
A multidiagonal (MD) code-based optical code division multiple-access (OCDMA) passive optical network (PON) is designed and analysed using conventional and optimised transmitter architectures. The system uses 32 wavelengths allocated to 16 remote nodes, with each node utilising a pair of wavelengths as specified by the MD code. Performance is assessed via OptiSystem simulation over fibre lengths from 10 to 25 km, considering different optical network unit (ONU) setups. Key performance metrics include bit error rate (BER) and Q -factor, with an examination of the effects of PIN and avalanche photodiode (APD) receivers. The findings indicate that the traditional architecture performs adequately, with BER below 10^−9, mainly for 16 ONUs. Still, performance drops notably at higher ONU counts owing to optical power loss at the transmitter, which is shown analytically to scale directly with the splitting and wavelength-discard losses rather than transmitter launch power alone. The improved transmitter design, employing selective wavelength combination before modulation, shows enhanced results, achieving BER well below the 10^−9 threshold and Q -factors up to 25 for 16 ONUs at 10 km with APD receivers. The power-budget derivation shows that the optimised architecture provides an optical power margin improvement of approximately 21 dB over the conventional design for the 16-remote node, 32-wavelength configuration considered. Reliable operation for 32 ONUs is also attainable across the entire fibre length with APD receivers. Nonetheless, both architectures face scalability issues beyond 128 ONUs, consistent with the increasing splitting loss predicted by the power-budget model. The research underscores the benefits of transmitter optimisation, supported by both simulation and analytical validation, in boosting the efficiency and dependability of MD-OCDMA PON systems.