European Journal of Wood and Wood Products Биологические науки
Lignin-based high-pressure laminates: effects of substitution level and hot-pressing time for high lignin formulations
Аннотация
The development of sustainable high-pressure laminates requires renewable alternatives to petrochemical phenol without compromising processing or performance. This work investigates hydroxy-methylated hardwood kraft lignin as a phenol substitute (0–80 wt%) in phenol–formaldehyde (PF) resins used for paper impregnation and lamination at 6.86 MPa and 150 °C for hot-pressing times of 10 and 30 min. A combination of chemical analysis, gel permeation chromatography, thermomechanical characterization, and end-use testing (EN 438-2) was applied to elucidate how lignin content and pressing conditions in highly lignin-based formulations influence resin reactivity, paper impregnation, and laminate properties. Substitution levels up to 50 wt% led to lignin–PF hybrid networks with low residual formaldehyde (< 0.7 mol L⁻¹) and good impregnation, yielding laminates with high stiffness (E′ = 14.2 GPa), a glass transition temperature of 151 °C, and excellent resistance to boiling water. At higher substitution levels (≥ 60 wt%), increased resin flow time and reduced formaldehyde conversion were associated with increased heterogeneity in the resulting laminate system, requiring extended pressing times to achieve laminate cohesion. However, extended hot-pressing did not invariably improve performance. At 50 wt% substitution, pressing for 30 min resulted in two distinct glass transitions, consistent with increased heterogeneity in the laminate system. Overall, the results demonstrate that lignin substitution level strongly influences resin characteristics, processing behavior, and laminate performance. Extended hot-pressing can be beneficial for highly lignin-based formulations but does not always lead to improved laminate properties.