Polymer Composites Ceramics and Composites
Stacking‐Sequence Effects on Polymer‐Laminate Damage Localization in Al 2 O 3 / UHMWPE and TiB 2 /Kevlar/Al Hybrid Systems Under High‐Velocity Impact
Abstract
ABSTRACT Polymer‐fiber laminates dissipate impact energy through tension, interlaminar separation, and deformation, with their response influenced by their position within hybrid targets. One light‐gas‐gun test at approximately 800 m/s was conducted for each of the Al 2 O 3 /UHMWPE and Kevlar/TiB 2 /Al targets. Three‐dimensional LS‐DYNA simulations and rear‐array acceleration measurements were used to investigate the impact response. The simulated Kevlar opening diameter differed from the measured value by 0.9%, while the UHMWPE rear‐face deflection was underpredicted by 19.5%. In ceramic‐front arrangements, ceramic fracture and lateral load spreading preceded pronounced polymer deformation. Reversing the ceramic–polymer order in simulations exposed the polymer to concentrated loading earlier, producing a narrower and more continuous axial tensile–shear damage path. Across the simulated velocity range, the central polymer damage‐zone width increased from 8.3 to 11.4 mm for Al 2 O 3 /UHMWPE and from 10.5 to 12.3 mm for Kevlar/TiB 2 /Al. Simulations bracketed full‐target perforation between 1200 and 1400 m/s in both architectures. In the front‐Kevlar simulations, the central damage path became more continuous between 800 and 1000 m/s while the full target remained unperforated. These velocity‐dependent findings are numerical predictions, with experimental support limited to the tested configurations at approximately 800 m/s.