Journal of Thermal Spray Technology Химия материалов

Thermal Spray as a Scalable Alternative Processing Route for Solid-State Thin-Film Batteries

Ameey Anupam, Arman Hasani, Gidla Vinay, Chinmayee Nayak, Nikhil Kamboj, Shrikant Joshi, Ashish Ganvir
Springer Nature · 2026-09-23 · DOI 10.1007/s11666-026-02327-x

Аннотация

Abstract Solid-state thin-film batteries (SSTFBs) are attractive for applications where small footprint, safety, long cycle life, and device integration are more important than high absolute capacity. Their fabrication, however, presently remains strongly tied to vacuum-based thin-film methods such as sputtering, pulsed laser deposition, evaporation, atomic layer deposition, and chemical vapour deposition. These routes provide dense and compositionally controlled layers, but their low deposition rates, high cost, limited coating area, and difficulty in building thicker active layers restrict their wider implementation for manufacturing. Thermal spray offers a distinct and versatile processing route that can deposit metals, ceramics, and composites from powder, suspension, or solution precursor feedstocks at significantly higher rates and over larger areas. This review assesses whether thermal spray approaches can be useful for SSTFB manufacture, while also considering the strict requirements of battery layers. The discussion first summarizes SSTFB materials and conventional processing constraints associated with them, before examining the suitability of thermal spraying as a processing platform based on its inherent characteristics in terms of thermal exposure, kinetic energy, feedstock response, phase retention, and coating/interface formation. Component-level compatibility is considered separately for SSTFB anodes, cathodes, solid electrolytes, and current collectors. Recent studies demonstrate that thermally sprayed battery constituents can exhibit electrochemical functionality, but alkali ion (lithium/sodium) loss, secondary phase formation, roughness, residual porosity, interfacial reactions, contamination control, and reproducibility remain key challenges. However, a strong near-term role of thermal spray is anticipated for fabrication of selected layers, current collectors, conductive interlayers, thicker active coatings, and hybrid architectures where complementary thin-film or post-treatment steps can address interface and electrolyte-quality requirements. The review concludes by proposing benchmark comparison criteria, minimum reporting parameters, and a staged roadmap for moving towards thermal-spray-enabled SSTFB manufacturing.

Читать у издателя →