Journal of Crop Health Сельское хозяйство и биологические науки (общие)

Detection of Drought Stress Effect On Tomato Plant Geometry Through 3D Models

Rezaee Roshan, Tahere, Jafari, Mehrnoosh, Gholami, Mahdiyeh, Kazemi, Mohsen
Springer Nature · 2026-10-31 · DOI 10.1007/s10343-026-01461-4

Аннотация

Using 3D models to measure plant vegetative characteristics is a non-invasive technique. The Structure-from-Motion (SfM) photogrammetric technique is recognized as the most prevalent passive optical method for 3D modeling. In this study, 3D models were employed to analyze the impact of drought stress on the geometries of tomato plants. Sixty CH Falat seedlings were split into three groups of twenty each, receiving different irrigation treatments: normal watering (C), water stress followed by re-irrigation (S-R), and complete cessation of watering (S). A custom-designed 360-degree turntable was built to capture images at 10-degree intervals from three distinct viewing angles. The study found high coefficients of determination for 3D models compared to ground truth measurements for stem height (0.98), stem diameter (0.96), and cumulated leaf area (0.99). Over a span of ten days, control plants exhibited a 149%, 3.9% and 22.5% expansion rate in cumulated leaf area, stem diameter, and height, respectively. Plants under S‑R treatment initially increased leaf area by 27% on the third day, but then decreased by 40% on the seventh day. Upon re-watering, the plants exhibited a notable enhancement in leaf area. This study revealed that soil moisture deficit led to a 25.6% reduction in the chlorophyll index of tomato plants. Results also indicated that the ion leakage percentage for control plants decreased by 17% over a ten-day period; however, for the S‑R and S treatments, the ion leakage percentage rose significantly by 178% and 186%, respectively.

Читать у издателя →