This study investigates the application of radio frequency (RF) hot pressing for the production of medium-density fiber-boards (MDF) utilizing lops and tops of Populus deltoides and urea-formaldehyde (UF) adhesive. MDF boards were manufactured at three RF durations (9, 12, and 15 min) and three pressure levels (17.5, 21.0, and 24.5 kg/cm^2) and evaluated as per IS: 12,406 (2003). The resulting boards were evaluated for their physical and mechanical properties, including water absorption, general and surface swelling, tensile strength, modulus of rupture, modulus of elasticity, and screw withdrawal strength. The results indicated that boards produced at an RF application duration of 15-minutes and a pressure of 24.5 kg/cm^2 met the requirement specified in IS:12,406 (2003). Boards manufactured at other RF durations and pressures also exhibited satisfactory physical and mechanical properties. The findings of this study highlight the potential of RF technology in MDF production, demonstrating its capacity for enhanced heat penetration and curing efficiency. These findings position RF hot pressing as a promising and innovative approach for MDF manufacturing, with the potential to optimize board performance and enhance production sustainability, thereby paving the way for future advancements in MDF technology.
Bhandari, Alok, Khali, Dwarika Prasad, Dhyani, Nirmal. Performance evaluation of MDF boards made from Populus deltoides using UF resin and radio frequency curing. // Journal of the Indian Academy of Wood Science. – 2026. – DOI: 10.1007/s13196-026-00418-4. – URL: http://link.springer.com/openurl/fulltext?id=doi:10.1007/s13196-026-00418-4
Bhandari, Alok, Khali, Dwarika Prasad, Dhyani, & Nirmal (2026). Performance evaluation of MDF boards made from Populus deltoides using UF resin and radio frequency curing. Journal of the Indian Academy of Wood Science. https://doi.org/10.1007/s13196-026-00418-4
Bhandari, et al. “Performance evaluation of MDF boards made from Populus deltoides using UF resin and radio frequency curing.” Journal of the Indian Academy of Wood Science, 2026. doi:10.1007/s13196-026-00418-4.
@article{Bhandari2026,
title = {Performance evaluation of MDF boards made from Populus deltoides using UF resin and radio frequency curing},
author = {Bhandari and Alok and Khali and Prasad, Dwarika and Dhyani and Nirmal},
journal = {Journal of the Indian Academy of Wood Science},
year = {2026},
doi = {10.1007/s13196-026-00418-4},
url = {http://link.springer.com/openurl/fulltext?id=doi:10.1007/s13196-026-00418-4}
}
The Calycophyllum spruceanum , known in Brazil, as “pau-mulato”, is a rapidly growing forest species native to the Amazon that produces dense wood used in floors, plywood, civil and naval construction and firewood, as it has high...
The growing demand for renewable energy sources has stimulated interest in biomass as a sustainable alternative, particularly the use of residues from the wood-processing industry. This study evaluated the energy potential of sawdust...
Fibrous lignocellulosic substrates such as wood used in the marine environment, eg., wooden docks, are highly susceptible to biofilm formation, which can progress to fouling, resulting in material degradation and increased maintenance...
Fiber-cement composites are used in lightweight construction due to their favorable balance of mechanical and physical properties. This study investigates the influence of rice husk-derived cellulose microfibers on the performance of...
This study details the fabrication and characterization of low-cost bio-based composite panels designed for sustainable construction and eco-friendly packaging. The non-structural boards utilize agricultural by-products, reinforcing a...